Speed Heater Controller
Mini II
Back to Speed Heater Controllers

Heating Studs on Stop Valves, Control Valves, Throttle Valves,
BFP's and RCP's

Boiler Feed Pump Application

Boiler Feed Pump

Remove BFP head in 1/2 shift with two men
Loosen each nut in 2-8 minutes
Heats two to four studs simultaneously
Compact model is hand carried to job

Reactor Coolant Pump

Loosen RCP flange in one to two hours
Reduce ALARA by 75%
Use standard bolting from OEM
Eliminate design change modifications
Heats two to four studs simultaneously

Turbine Control/Stop and Throttle Valves

Remove valve bonnets in one hour
Loosen each nut in 2-8 minutes
Heats two to four studs simultaneously

Speed Heating Benefits:
Speed Heating Benefits Loosens any diameter bolting in minutes Compact model is hand carried or rolled to job No cooling water necessary as in induction bolt heating Uses 480 volt 3Ph 80 amp power supply	Costs less than an hydraulic torque wrench and more economical than induction bolt heating Training in less than 1 hour Eliminate outside contractors using induction bolt heating Heats two to four studs simultaneously. Induction bolt heating only heats one stud at a time.

Power House Tool, Inc. 626 Nicholson Street Joliet, IL 60435 Phone: (815) 727-6301 * Fax (815) 727-4835 www.powerhousetool.com	JNT Technical Services Inc. 85 Industrial Avenue Little Ferry, New Jersey 07643 Phone: 201 641-2130 Fax: 201 641-2309 www.jnt-tech-serv.com
©Copyright Power House Tool, Inc. and JNT Technical Services, Inc. All Rights Reserved.